Firmware Update for TX-NR5009

Notice of Firmware Update for TX-NR5009
A firmware update for the TX-NR5009 network A/V receiver is available through the unit’s network connection or USB input. Please note that new firmware updates replace, and include all content from, previous updates. The latest update includes the following content:

How to Check if Your Firmware Version is Up To Date
To Check if your firmware is up to date, go into Setup -> Hardware Setup -> Firmware Update and check the 16-digit number (xxxx-xxxx-xxxx-xxxx). If any numbers differ from the latest version available, please update your unit.

Precautions for TX-NR5009 Firmware Update

• Please read the update instructions carefully before beginning.
• The firmware update should take 30 to 40 minutes. Once the update begins, don’t turn off the power supply to the A/V receiver until it is time to restart it.
• Depending on the conditions of the network, a firmware update via a network may take more than one hour or even fail to finish. If the update is not completed within two hours, turn off the power supply by pushing the ON/STANDBY button and then try updating again from the beginning.
• Updating the firmware and adjusting the settings will be done automatically, but may take some time to complete. Please follow the procedures as instructed when you update. Note that the update may fail, or cause problems for your A/V receiver, if you do any of the following:

• Pull out the A/V receiver’s power cord;
• Interrupt the power supply to the A/V receiver (e.g. if the breaker is tripped or if there is an electrical outage);
• Insert or remove the LAN cable from a device in your network when updating over a network;
• Insert or remove a USB memory device from the A/V receiver when updating via USB;
• Operate components connected to the A/V receiver via HDMI, such as a TV or a recording device.

If your A/V receiver is damaged for any of the reasons above, an Onkyo service center will repair the unit for a fee.

How to Install Firmware Update for TX-NR5009
Click below for instructions on how to install the update. Instructions cover (1) direct update over network connection and (2) update via USB.

• How to install

  

Click below to download the firmware update to your PC, for subsequent installation on your receiver via its USB port.

Download Update to Your PC